| Hangar |
Aircraft |
Category |
Date |
Preview |
| jerry campbell | Dave Diels Engineering, Inc Kit #41, Mitsubishi J2M3 Radien "Jack" | Build | 02-Jun-09 23:29 |  | | Views : 755 | | The instrument panel is a decal left over from something. The cockpit isn't much, but better than nothing. |
| jerry campbell | Dave Diels Engineering, Inc Kit #41, Mitsubishi J2M3 Radien "Jack" | Build | 02-Jun-09 23:27 |  | | Views : 656 | | The huge Raiden cockpit needed a little something so I quickly fabricated a seat to fill up some of the space. |
| jerry campbell | Dave Diels Engineering, Inc Kit #41, Mitsubishi J2M3 Radien "Jack" | Build | 27-May-09 22:18 |  | | Views : 664 | | The wing fillets in plance, its about time to think about some paint. |
| jerry campbell | Dave Diels Engineering, Inc Kit #41, Mitsubishi J2M3 Radien "Jack" | Build | 27-May-09 22:15 |  | | Views : 714 | | The cockpit area has had the first coat of paint airbrushed. |
| jerry campbell | Dave Diels Engineering, Inc Kit #41, Mitsubishi J2M3 Radien "Jack" | Build | 25-May-09 23:16 |  | | Views : 690 | | Rather than use stiff paper on the rear of the wing fillets I use Eske, but I will have to use stiff paper on the forward fillets. |
| jerry campbell | Dave Diels Engineering, Inc Kit #41, Mitsubishi J2M3 Radien "Jack" | Build | 25-May-09 23:07 |  | | Views : 714 | | After the lower surfaces were covered then the wing fillets are left to be added. |
|
| Hangar |
Aircraft |
Category |
Date |
Preview |
| jerry campbell | Dave Diels Engineering, Inc Kit #41, Mitsubishi J2M3 Radien "Jack" | Build | 25-May-09 23:04 |  | | Views : 616 | | The stringers installed it was a simple matter of covering, which went much better than inticipated. |
| jerry campbell | Dave Diels Engineering, Inc Kit #41, Mitsubishi J2M3 Radien "Jack" | Build | 22-May-09 19:29 |  | | Views : 651 | |
| jerry campbell | Dave Diels Engineering, Inc Kit #41, Mitsubishi J2M3 Radien "Jack" | Build | 19-May-09 12:46 |  | | Views : 676 | | The lower nose air intake is laminated together and then must be dug out and sanded to shape. The supplied balsa is good quality and the shaping and sanding went well. |
| jerry campbell | Dave Diels Engineering, Inc Kit #41, Mitsubishi J2M3 Radien "Jack" | Parked | 19-May-09 12:42 |  | | Views : 638 | | Once the wings are glued into place the lower stringers will be added. |
| jerry campbell | Dave Diels Engineering, Inc Kit #41, Mitsubishi J2M3 Radien "Jack" | Build | 19-May-09 12:39 |  | | Views : 628 | | With a little trimming the wings fit well. |
| jerry campbell | Dave Diels Engineering, Inc Kit #41, Mitsubishi J2M3 Radien "Jack" | Build | 19-May-09 12:36 |  | | Views : 621 | | finally back to work on the Raiden. Papering is done except for the lower fuselage surfaces and with only minor problems to solve around the nose. |
|
