| Hangar |
Aircraft |
Category |
Date |
Preview |
| edtherenderman | Guillows Series 200 - Rumpler C5 | Build | 07-Jun-21 10:09 |  |
| Views : 750 |
| Been very busy 3D modeling and printing parts. Also, lots of modifications to the fuse to accept the new cockpit covers and all the added interior detail. Starting to assemble and paint the plastic parts now. Again, Wingnut Wings (http://www.wingnutwings.com/ww/) has been an amazing resource! If you are building WW1 models, check out their site! Pictures of both the original aircraft and the models are amazing. I've not bought one of their models yet, but they must be amazing! |
| edtherenderman | Guillows Series 200 - Rumpler C5 | Build | 07-Jun-21 10:05 |  |
| Views : 825 |
| Been quite on the Rumpler, but still working on it. Now have everything but the fuse covered and doped to high sheen. |
| edtherenderman | Guillows Series 200 - Rumpler C5 | Build | 03-May-21 08:23 |  |
| Views : 914 |
| Finished modeling and 3D printing the Daimler-Mercedes D.IVa engine this week end. Had a couple of failed prints, and the print job with the cylinders took about 7 hours to run, but I did get it done. Note that the engine will be about 2.25” fully built. I also modeled in a spinning prop shaft, so if all goes well, I can put on a prop that will turn relatively easily. We shall see. (I think it’s time I find a new parts cutting board to photograph my part on! This one has seen better days!) |
| edtherenderman | Guillows Series 200 - Rumpler C5 | Build | 25-Apr-21 19:19 |  |
| Views : 989 |
|
| edtherenderman | Guillows Series 200 - Rumpler C5 | Build | 25-Apr-21 19:19 |  |
| Views : 976 |
|
| edtherenderman | Guillows Series 200 - Rumpler C5 | Build | 25-Apr-21 19:18 |  |
| Views : 820 |
|
