| Hangar |
Aircraft |
Category |
Date |
Preview |
| edtherenderman | Scratch Built Bugatti 100P | Build | 14-Nov-21 19:47 |  | | Views : 695 | | 3D modeled and printed the spinners and propellers. These are just press fitted at this point and still have some fitting to do, but the results look good. Spinners were done with my FDM printer using Polysmooth filament. The propellers were done with my SLA printer. |
| edtherenderman | Scratch Built Bugatti 100P | Build | 14-Nov-21 19:45 |  | | Views : 666 | | Port side exhaust fairing for back engine and cooling air outlet on trailing edge of wing. |
|
| Hangar |
Aircraft |
Category |
Date |
Preview |
| edtherenderman | Scratch Built Bugatti 100P | Build | 14-Nov-21 19:44 |  | | Views : 656 | | Bottom View |
| edtherenderman | Scratch Built Bugatti 100P | Build | 14-Nov-21 19:44 |  | | Views : 689 | | Taking a break for the holidays so thought I’d post the current state of the Bugatti. 3D printed exhaust fairing and cooling air outlets that are on the trailing edge of the wings. Glued and filled with spackling, then coated entire model with five coats of thinned EZ-DOPE. Finally, two coats of sanding primer. Next will be sanding the primer and filling anything that needs it. |
|
