| Hangar |
Aircraft |
Category |
Date |
Preview |
| David Duckett | Easy Built D-03 Avro Lancaster | Build | 26-Jan-12 07:22 |  |
| Views : 1298 |
| Several notches had to be adjusted to keep the stringers in line but that's expected and didn't cause a problem. Former #3 was about 1/16" high on the beam so it got sliced a bit more. Next step is to infill the bottom center section so the first two blocks can be put in place. |
| David Duckett | Easy Built D-03 Avro Lancaster | Build | 26-Jan-12 07:15 |  |
| Views : 1303 |
| Well, that was easy enough. This is all the stringers and there are six (6) balsa blocks to be added and carved to complete the fuselage per plan. At this point it really wouldn't need much sanding before covering. |
| David Duckett | Easy Built D-03 Avro Lancaster | Build | 24-Jan-12 05:01 |  |
| Views : 1235 |
|
| David Duckett | Easy Built D-03 Avro Lancaster | Build | 24-Jan-12 05:01 |  |
| Views : 1331 |
|
| David Duckett | Easy Built D-03 Avro Lancaster | Build | 24-Jan-12 03:51 |  |
| Views : 1375 |
| THe top sub formers are installed in the same manner. Wing and stabilizer outline parts are then added. There are 4 or 5 more small pieces to add before adding the stringers. |
| David Duckett | Easy Built D-03 Avro Lancaster | Build | 24-Jan-12 03:48 |  |
| Views : 1324 |
| Once the formers front and back are in place, the 3/16" x 1/16" strip is glued into place on each side on the bottom. The remaining sub formers are then glued into place. |
