| Hangar |
Aircraft |
Category |
Date |
Preview |
| SteveM | Guillows Fokker D-VIII | Build | 19-Feb-08 22:07 |  | | Views : 14317 | | The mold halves. The one on the right came out great but the one on the left has air bubble issues. |
| John M Oshust | Scratch Built Polikarpov I-16 Rata | Build | 19-Feb-08 21:03 |  | | Views : 1556 | | Short and tubby with a very large wing! |
| SteveM | Guillows Fokker D-VIII | Build | 19-Feb-08 18:06 |  | | Views : 13766 | | In about 4 hours (7pm PST) the top half will be cured and I can start casting some resin. Rubber mold cost is about $6, not too bad but don't go crazy with it. |
| SteveM | Guillows Fokker D-VIII | Build | 19-Feb-08 18:04 |  | | Views : 14009 | | Alignment lugs carved out and rubber-to-rubber release agent applied. Don't worry, I'll add this whole process to my web page on duplicating plastic parts. |
| OLD A&P | SIG Cabinaire | Parked | 19-Feb-08 17:33 |  | | Views : 13796 | | I left the wheel pants off to save a little weight. |
| OLD A&P | SIG Cabinaire | Parked | 19-Feb-08 17:31 |  | | Views : 13613 | | All done and good to go |
|
|
