| Hangar |
Aircraft |
Category |
Date |
Preview |
| David Duckett | Guillows Fokker D-VIII | Build | 17-Feb-08 18:05 |  | | Views : 1396 | | Some filler on the bottom where the struts fit |
| David Duckett | Guillows Fokker D-VIII | Build | 17-Feb-08 18:03 |  | | Views : 1235 | | Wingtips and center section are several layers of balsa, sanded and Micro-Fill smeared on and sanded smooth when dry. |
| moostang51 | Guillows Series 800 - Mosquito | Build | 17-Feb-08 16:37 |  | | Views : 1417 | | One nacelle complete. The grillwork is very rigid and just test fitted. Will be permanently installed as one of the Mossies final details, probably in 2009 at this rate. |
| moostang51 | Guillows Series 800 - Mosquito | Build | 17-Feb-08 16:33 |  | | Views : 1400 | | The plastic becomes mighty thin at the edges after sanding. Look close, the tabs were wonderful alignment strips and provided more area for glue up at seams. Priceless. |
| moostang51 | Guillows Series 800 - Mosquito | Build | 17-Feb-08 14:50 |  | | Views : 1450 | | After all trial fitting and shaping, the 1/16" balsa sheet is glued into position to reinforce thin nacelle sides during glue up. Will also back-up any filler required. Thank you DD. |
| moostang51 | Guillows Series 800 - Mosquito | Build | 17-Feb-08 14:47 |  | | Views : 1428 | | Nacelle on left after glue up, filler and one coat primer at seam. Right nacelle glue up only. Any trace of seam will provide stencil for panel line. |
|
|
