| Hangar |
Aircraft |
Category |
Date |
Preview |
| Don C | Scratch Built Laird Solution | Build | 02-Dec-16 13:00 |  | | Views : 582 | | Still going. R to L: Motor mount from photos, crankcase accordingto plan,cylinders from Dare motor, intake from Dare motor kit. Should produce a reasonable facsimile of a P&W Wasp Jr. Fortunately it's mostly hidden by the cowl. |
| Don C | Scratch Built Laird Solution | Build | 25-Oct-16 15:41 |  | | Views : 617 | | Rudder pedals . Need to clean and paint before installation. |
| Don C | Scratch Built Laird Solution | Build | 25-Oct-16 15:36 |  | | Views : 627 | | Cockpit floored and sided. Not sure if I will do the panel like this or not. |
| Don C | Scratch Built Laird Solution | Build | 25-Oct-16 15:30 |  | | Views : 651 | | Cowling now has aerodynamic warts. |
| Don C | Scratch Built Laird Solution | Build | 25-Oct-16 15:29 |  | | Views : 735 | | Got them on an axle. |
| Don C | Scratch Built Laird Solution | Build | 07-Sep-16 17:43 |  | | Views : 701 | | Not much progress on the Solution, but I did find wheels for 50 cents at a thrift store.Closer to scale than most anything online. Lots of nice work going on. Compliments to al.l |
|
| Hangar |
Aircraft |
Category |
Date |
Preview |
| Don C | Scratch Built Laird Solution | Build | 02-Aug-16 18:27 |  | | Views : 744 | | Progress report: All covered with silkspan and 3 coats of dope. Deciding on next step. |
| Don C | Scratch Built Laird Solution | Build | 02-Aug-16 18:23 |  | | Views : 812 | |
| Don C | Scratch Built Laird Solution | Reference | 21-Jul-16 11:37 |  | | Views : 892 | | Anders, I know it's not a Rumpler, but I thought the art work was interesting. DD's info was better than anything I found. |
| Don C | Scratch Built Laird Solution | Reference | 21-Jul-16 11:31 |  | | Views : 890 | |
| Don C | Scratch Built Laird Solution | Reference | 29-Jun-16 13:06 |  | | Views : 791 | | Road trip to Minnesota: One tick bite and one good picture. Yesterday PM , north central Montana. |
| Don C | Scratch Built Laird Solution | Build | 14-Jun-16 11:17 |  | | Views : 683 | | Thanks for the idea, DD. Works much better. Also made the stringers heavier - 1/16 X 1/8. Will require some sanding. The balsa I get from my LHS is very good and consistent in quality, but it is soft as a slice of fresh white bread. That means my nimble fingers break a few pieces. Any ideas for getting a little harder balsa? |
|
