| Hangar |
Aircraft |
Category |
Date |
Preview |
| Don C | Scratch Built Basler BT-67 | Build | 20-Feb-20 12:22 |  |
| Views : 627 |
| If I were smart enogh, one of those lasr cutters would be nice. |
| Don C | Scratch Built Basler BT-67 | Build | 20-Feb-20 12:19 |  |
| Views : 644 |
| After 3 applicaations of spackle, this is 1 coat of sandable promer sanded just until some wood appears. Any rough spots stand out like a sore thumb/ |
| Don C | Scratch Built Basler BT-67 | Build | 18-Feb-20 14:19 |  |
| Views : 660 |
| Rough sanded after coloring the ribs and stringers red. Theis is the first coat of spackle. So far I have only broken the little wingtip piece off once. Any guesses what the numbr will be by the time it's done? |
| Don C | Scratch Built Basler BT-67 | Build | 18-Feb-20 14:11 |  |
| Views : 644 |
| Ed, this might explain better. This is the bottom. When doing the top I could put the CA nozzle through and apply it to the inside of the wing. Here I fit the pice of infill and then apple the Testor's green to the sides of the hole and then place the piece of infill into the hole. |
| Don C | Scratch Built Basler BT-67 | Build | 17-Feb-20 13:18 |  |
| Views : 688 |
| Both wings built, one infilled, the other half. Ed, I've cut enough balsa to last a while and I still have the fuselage to go. :( LIke your system very much. |
| Don C | Scratch Built Basler BT-67 | Build | 17-Feb-20 13:15 |  |
| Views : 745 |
| Wing center section infilled. Instructions from both plans are quite similar. |
