| Hangar |
Aircraft |
Category |
Date |
Preview |
| jerry campbell | Dave Diels Engineering, Inc Kit #41, Mitsubishi J2M3 Radien "Jack" | Build | 25-May-09 23:16 |  | | Views : 1138 | | Rather than use stiff paper on the rear of the wing fillets I use Eske, but I will have to use stiff paper on the forward fillets. |
| jerry campbell | Dave Diels Engineering, Inc Kit #41, Mitsubishi J2M3 Radien "Jack" | Build | 25-May-09 23:07 |  | | Views : 1133 | | After the lower surfaces were covered then the wing fillets are left to be added. |
| jerry campbell | Dave Diels Engineering, Inc Kit #41, Mitsubishi J2M3 Radien "Jack" | Build | 25-May-09 23:04 |  | | Views : 1013 | | The stringers installed it was a simple matter of covering, which went much better than inticipated. |
| David Duckett | Dave Diels Engineering, Inc Kit #41, Mitsubishi J2M3 Radien "Jack" | Reference | 22-May-09 19:55 |  | | Views : 1379 | | This is a 1/48 scale plastic model, not mine. |
| David Duckett | Dave Diels Engineering, Inc Kit #41, Mitsubishi J2M3 Radien "Jack" | Reference | 22-May-09 19:52 |  | | Views : 1450 | |
| jerry campbell | Dave Diels Engineering, Inc Kit #41, Mitsubishi J2M3 Radien "Jack" | Build | 22-May-09 19:29 |  | | Views : 1100 | |
|
| Hangar |
Aircraft |
Category |
Date |
Preview |
| jerry campbell | Dave Diels Engineering, Inc Kit #41, Mitsubishi J2M3 Radien "Jack" | Build | 19-May-09 12:46 |  | | Views : 1132 | | The lower nose air intake is laminated together and then must be dug out and sanded to shape. The supplied balsa is good quality and the shaping and sanding went well. |
| jerry campbell | Dave Diels Engineering, Inc Kit #41, Mitsubishi J2M3 Radien "Jack" | Parked | 19-May-09 12:42 |  | | Views : 1112 | | Once the wings are glued into place the lower stringers will be added. |
| jerry campbell | Dave Diels Engineering, Inc Kit #41, Mitsubishi J2M3 Radien "Jack" | Build | 19-May-09 12:39 |  | | Views : 1083 | | With a little trimming the wings fit well. |
| jerry campbell | Dave Diels Engineering, Inc Kit #41, Mitsubishi J2M3 Radien "Jack" | Build | 19-May-09 12:36 |  | | Views : 1085 | | finally back to work on the Raiden. Papering is done except for the lower fuselage surfaces and with only minor problems to solve around the nose. |
| jerry campbell | Dave Diels Engineering, Inc Kit #41, Mitsubishi J2M3 Radien "Jack" | Build | 19-Apr-09 20:38 |  | | Views : 1111 | | I'm starting to fill with pieces around to cockpit and nose ala DD. It sure makes working in these areas much easier. Sure got a lot of dust to make. |
| jerry campbell | Dave Diels Engineering, Inc Kit #41, Mitsubishi J2M3 Radien "Jack" | Build | 19-Apr-09 20:35 |  | | Views : 1070 | |
|
