| Hangar |
Aircraft |
Category |
Date |
Preview |
| David Duckett | Dave Diels Engineering, Inc Kit #23, Grumman F7F-3 Tigercat | Build | 30-Aug-09 18:04 |  | | Views : 1081 | | The national insignia and letters will be painted on so to facilitate that, the stabilizer will not be attached until that's done. |
| David Duckett | Dave Diels Engineering, Inc Kit #23, Grumman F7F-3 Tigercat | Build | 30-Aug-09 17:59 |  | | Views : 1098 | | Everything is covered except the control surfaces which will be covered and painted before assembly. |
| David Duckett | Dave Diels Engineering, Inc Kit #23, Grumman F7F-3 Tigercat | Build | 30-Aug-09 17:58 |  | | Views : 1173 | | The nacelle is covered except for the area in front of the fill in and is glued in place. |
| David Duckett | Dave Diels Engineering, Inc Kit #23, Grumman F7F-3 Tigercat | Build | 30-Aug-09 17:55 |  | | Views : 1096 | | Hobbylite filler, 'fore & after |
| David Duckett | Dave Diels Engineering, Inc Kit #23, Grumman F7F-3 Tigercat | Build | 28-Aug-09 21:53 |  | | Views : 1162 | | Covering of the nacelles and stabilizer is next. |
| David Duckett | Dave Diels Engineering, Inc Kit #23, Grumman F7F-3 Tigercat | Build | 28-Aug-09 21:51 |  | | Views : 1123 | | The fuselage is completely covered except for the tail and nose blocks. The wing has been CA'd in place and filler added. |
|
| Hangar |
Aircraft |
Category |
Date |
Preview |
| David Duckett | Dave Diels Engineering, Inc Kit #23, Grumman F7F-3 Tigercat | Build | 28-Aug-09 21:48 |  | | Views : 1134 | | A soft balsa 1/16" stringer for fill.... |
| David Duckett | Dave Diels Engineering, Inc Kit #23, Grumman F7F-3 Tigercat | Build | 28-Aug-09 21:47 |  | | Views : 1122 | |
| David Duckett | Dave Diels Engineering, Inc Kit #23, Grumman F7F-3 Tigercat | Build | 28-Aug-09 13:35 |  | | Views : 1076 | | Since I'm covering too, here's a closer look. |
| David Duckett | Dave Diels Engineering, Inc Kit #23, Grumman F7F-3 Tigercat | Build | 28-Aug-09 13:33 |  | | Views : 1250 | | So you know where to cut... |
| David Duckett | Dave Diels Engineering, Inc Kit #23, Grumman F7F-3 Tigercat | Build | 25-Aug-09 19:48 |  | | Views : 1170 | | The wing halves were covered separately and have now been CA'd together and.....IT FITS!!! |
| David Duckett | Dave Diels Engineering, Inc Kit #23, Grumman F7F-3 Tigercat | Build | 23-Aug-09 17:34 |  | | Views : 1142 | | 2 scoops, please. I put filler into the scoop and used the rounded end of a small paint brush to round the contact area. Any further refinements will be done when covering and painting. 5 cents, please. |
|
