| Hangar |
Aircraft |
Category |
Date |
Preview |
| Don C | Scratch Built Vultee BT-13 | Build | 10-Nov-21 21:24 |  |
| Views : 663 |
| This should be 1st . ready to go. Oven heated to 280. Let it heat for about 5 minutes, then move quickly. If it doesn't go all the way down over the mold, back in the oven for a longer time. It will flatten out and give you a second chance.. |
| Don C | Scratch Built Vultee BT-13 | Build | 10-Nov-21 21:18 |  |
| Views : 672 |
| Its helpful to mark where to cut before removing it from the form. I made 2 in case I messone up fitting or painting. |
| Don C | Scratch Built Vultee BT-13 | Build | 10-Nov-21 21:15 |  |
| Views : 706 |
| Cooled . Haad ro work a bit to get it off the form |
| Don C | Scratch Built Vultee BT-13 | Build | 06-Nov-21 20:38 |  |
| Views : 688 |
| Center is fairly easy. Always redrawing lines to keep a center. Hope this help[s, Ed. |
| Don C | Scratch Built Vultee BT-13 | Build | 06-Nov-21 20:16 |  |
| Views : 709 |
| Basic form finished. Front and rear will be ,hopefully cut to final shape after it's formed. dry |
| Don C | Scratch Built Vultee BT-13 | Build | 04-Nov-21 14:13 |  |
| Views : 700 |
| Edbecky - Here's the start to carvomg a mold for the canopy. I'll try to remember to post strps as I go so you can see them. |
