| Hangar |
Aircraft |
Category |
Date |
Preview |
| Don C | Scratch Built Basler BT-67 | Build | 18-Feb-20 14:19 |  |
| Views : 414 |
| Rough sanded after coloring the ribs and stringers red. Theis is the first coat of spackle. So far I have only broken the little wingtip piece off once. Any guesses what the numbr will be by the time it's done? |
| Don C | Scratch Built Basler BT-67 | Build | 18-Feb-20 14:11 |  |
| Views : 408 |
| Ed, this might explain better. This is the bottom. When doing the top I could put the CA nozzle through and apply it to the inside of the wing. Here I fit the pice of infill and then apple the Testor's green to the sides of the hole and then place the piece of infill into the hole. |
| Don C | Scratch Built Basler BT-67 | Build | 17-Feb-20 13:18 |  |
| Views : 444 |
| Both wings built, one infilled, the other half. Ed, I've cut enough balsa to last a while and I still have the fuselage to go. :( LIke your system very much. |
| Don C | Scratch Built Basler BT-67 | Build | 17-Feb-20 13:15 |  |
| Views : 512 |
| Wing center section infilled. Instructions from both plans are quite similar. |
| Don C | Scratch Built Basler BT-67 | Reference | 11-Feb-20 10:13 |  |
| Views : 595 |
| Sure. MIght have to modify it a bit, though. |
| Don C | Scratch Built Basler BT-67 | Build | 08-Feb-20 19:50 |  |
| Views : 434 |
| Hadn't figured out howI would do the elevator . It's sheeted now. Red is fso I don't oversand when forming the airfoil.. |
