Hangar |
Aircraft |
Category |
Date |
Preview |
SteveM | Guillows Series 400 - P-51 Mustang | Flying | 06-Oct-08 02:14 | ![](user_aircraft_thumb600/9462.jpg) | Views : 860 | I went with the pull-pull setup to the tail wheel and a push rod to the rudder and elevator. Most of this gets covered as is and will require cutting into the covering if a repair or adjustment is needed. |
SteveM | Guillows Series 400 - P-51 Mustang | Build | 04-Oct-08 17:23 | ![](user_aircraft_thumb600/9450.jpg) | Views : 785 | I haven't quite figured out yet how to best link up the rear wheel as the little arm for it moves not just in the X-Y plane but also a little in the Z plane. My best ideas so far are to either use an elastic material or a pull-pull. |
|
Hangar |
Aircraft |
Category |
Date |
Preview |
SteveM | Guillows Series 400 - P-51 Mustang | Build | 04-Oct-08 17:20 | ![](user_aircraft_thumb600/9449.jpg) | Views : 831 | The motor is mounted and stringers are starting to go on. If you look close you can see push rods for the rudder and elevator. |
SteveM | Guillows Series 400 - P-51 Mustang | Build | 26-Sep-08 16:37 | ![](user_aircraft_thumb600/9416.jpg) | Views : 845 | I finally got around to fixing the tail wheel. I used 1/32" plywood for the support which will hopefully be strong enough without adding too much weight. |
|