Build Thread, Page :
1 2 [ 3 ] 4 5 6 7 8 9 (170 posts, 20 posts per page, 9 pages in total)
|
[ < Prev ] [ Next > ] |
bobgood, Comment for image # 44507 | 18 Mar 24 08:59 |
Great colour scheme Don - nice! |
Don C, Comment for image # 44508 | 17 Mar 24 23:07 |
Wheel wells a work in progress. 4 redos so far. |
Don C, Image # 44508 | 17 Mar 24 23:04 |
Flaps,aileronsshell casing ports done after 3 or 4 tries. |
Don C, Image # 44507 | 17 Mar 24 22:59 |
Canopy is on. |
Don C, Comment for image # 44500 | 16 Mar 24 23:11 |
Always, Brian and even then I miss. |
BriandKilby, Comment for image # 44500 | 16 Mar 24 08:01 |
I have shaky hand syndrome too. Have to stabilize my hand with my other hand, sometimes. |
Don C, Comment for image # 44500 | 15 Mar 24 14:41 |
Still have to write short comments, James. |
Don C, Comment for image # 44500 | 15 Mar 24 14:36 |
There are 4 layers of tape to make an edge. |
Don C, Comment for image # 44500 | 15 Mar 24 14:34 |
and will try again today. |
Don C, Comment for image # 44500 | 15 Mar 24 14:34 |
Yesterday I was so shaky I painted the white over |
Don C, Comment for image # 44500 | 15 Mar 24 14:31 |
Took 3 tries to get it right. |
Don C, Comment for image # 44500 | 15 Mar 24 14:31 |
Actually I ran over everything. |
BriandKilby, Comment for image # 44500 | 14 Mar 24 08:56 |
How do you trace the outline, say the rudder, without running over the paper? |
Don C, Comment for image # 44500 | 13 Mar 24 21:23 |
And keep a wet paper towel handy.
|
Don C, Comment for image # 44500 | 13 Mar 24 21:22 |
So I use water based ink. |
Don C, Comment for image # 44500 | 13 Mar 24 21:15 |
Works well when your hands are steady. |
BriandKilby, Comment for image # 44500 | 11 Mar 24 09:46 |
Nice method. Comes out at the right size. |
Don C, Comment for image # 44501 | 09 Mar 24 22:14 |
Canopy attached. |
Don C, Image # 44502 | 09 Mar 24 22:13 |
CANOPY |
Don C, Image # 44500 | 09 Mar 24 22:12 |
Marking control surfaces. |
Build Thread, Page :
1 2 [ 3 ] 4 5 6 7 8 9 (170 posts, 20 posts per page, 9 pages in total)
|
[ < Prev ] [ Next > ] |