| Hangar |
Aircraft |
Category |
Date |
Preview |
| Don C | Scratch Built Basler BT-67 | Parked | 06-May-21 12:13 |  |
| Views : 3101 |
| So I got tired of waiting until we could drive to the east coast to deliver thiis to my son in law. Went to UPS to check. $400 to send it from Montana to Maryland.I said "No". Guess he'll just have to wait. |
| bsadonkill | Guillows Series 600 - Cessna 180 | Parked | 06-May-21 10:30 |  |
| Views : 6975 |
| SEE! much better. |
| bsadonkill | Guillows Series 600 - Cessna 180 | Parked | 06-May-21 10:28 |  |
| Views : 6925 |
| A better flying 600 series Cessna, with removable nose plug and washed out wing tips. |
| mark eggebeen | Guillows Series 2000 - PBY Catalina | Build | 04-May-21 16:23 |  |
| Views : 1189 |
| lots of compound curves coming up |
| mark eggebeen | Guillows Series 2000 - P-38 Lightning | Build | 03-May-21 22:38 |  |
| Views : 6824 |
| getting started |
| edtherenderman | Guillows Series 200 - Rumpler C5 | Build | 03-May-21 08:23 |  |
| Views : 837 |
| Finished modeling and 3D printing the Daimler-Mercedes D.IVa engine this week end. Had a couple of failed prints, and the print job with the cylinders took about 7 hours to run, but I did get it done. Note that the engine will be about 2.25” fully built. I also modeled in a spinning prop shaft, so if all goes well, I can put on a prop that will turn relatively easily. We shall see. (I think it’s time I find a new parts cutting board to photograph my part on! This one has seen better days!) |
