| Hangar |
Aircraft |
Category |
Date |
Preview |
| SteveM | Peck Polymers One Nite 28 | Build | 08-Mar-08 23:13 |  |
| Views : 1037 |
| 3x110 mAh NiCd and 5 amp fuse (goes into the yellow socket) acts as a switch. Fuselage also had 4" cut off of the front. |
| SteveM | Peck Polymers One Nite 28 | Flying | 08-Mar-08 18:36 |  |
| Views : 957 |
| These flights are all done with hand winding as the winder broke and CA wouldn't hold it together. I managed to get some 15-20 second flights and then decided my poor wrist and finger were tired of winding and it was time for electric FF conversion. |
| SteveM | Peck Polymers One Nite 28 | Flying | 08-Mar-08 18:33 |  |
| Views : 959 |
| Went to the park today and tried the One Nite 28 with rubber powered FF. |
| wingspanner | West Wings Spitfire Mk 22/24 | Build | 08-Mar-08 18:04 |  |
| Views : 1763 |
| Managed to get the Engine rocker fairings glued and gave the whole plane a few coats of Krylon. Busy setting the tailplane and fin in place. Then to coat it with primer and an attempt at airbrushing. |
| John M Oshust | Scratch Built Polikarpov I-16 Rata | Build | 08-Mar-08 17:50 |  |
| Views : 820 |
| I must be feeling normal, 6 hrs today and the wing root is totally covered. |
| John M Oshust | Scratch Built Polikarpov I-16 Rata | Build | 08-Mar-08 15:58 |  |
| Views : 797 |
| Somewhere in this balsa block is the tail piece to the fuse, I shall try to set it free tomorrow! |
