|
|
| Hangar |
Aircraft |
Category |
Date |
Preview |
| moostang51 | Guillows Series 2000 - B-24 Liberator | Build | 15-Jun-07 18:35 |  | | Views : 2003 | | New carved rudder. Starts as a 1/2 stock. First cut through notch for stabilizer then lots of shaping and sanding. Used the Guillows plan for final profile. |
| jerry campbell | Dave Diels Engineering, Inc Kit #43, Ki 84 Hayate "Frank" | Build | 15-Jun-07 15:28 |  | | Views : 1371 | | I use small fuel line to simulate the landing gear. It is extremely flexible and slips easily onto the landing gerar wire after it is bent. I've now got to add strips fo masking take to simulate the hydraulic ridges. |
| jerry campbell | Dave Diels Engineering, Inc Kit #43, Ki 84 Hayate "Frank" | Build | 15-Jun-07 15:17 |  | | Views : 1715 | | The sleek shape of the "Frank" is finally taking shape. The Hayate (Hurricane) in the hands of an experienced pilot could out fly both the Musttang and Hellcat. |
| jerry campbell | Dave Diels Engineering, Inc Kit #43, Ki 84 Hayate "Frank" | Build | 15-Jun-07 15:09 |  | | Views : 1453 | | The engine cowling is built up with rings of balsa and was a bit of a job carvng and sanding to shape as well as cutting and shaping the air intake . You can see where the stringers must still be added to the fuselage. |
| jerry campbell | Dave Diels Engineering, Inc Kit #43, Ki 84 Hayate "Frank" | Build | 15-Jun-07 14:57 |  | | Views : 1404 | | The major components are doped, sanded, and papered. The lower third of the fuselage will be papered after the wing has been added to the fuslelage and the l ower stringers are in place. |
| jernst | Dave Diels Engineering, Inc Kit #39, Aichi D3A1 "Val" | Parked | 15-Jun-07 13:55 |  | | Views : 4745 | | Diels Aichi D3A1 'Val'; 24 in span - with major wing panel 'flexing' under tissue compression |
|
