| Hangar |
Aircraft |
Category |
Date |
Preview |
| pfinn | Jetco Dayton-Wright RB-1 | Build | 27-Jan-11 11:30 |  |
| Views : 625 |
| I'm using the fuse jig with a "Top/Bottom" orientation. A temporary cross member adhered to each bulkhead flush (or parallel) to the waist keel formers. I've seen builders tack glue these cross members then use a solvent to remove them later. I used my Super Dilly Delux double stick tape instead. I've marked centerline and 2' offset on the cross members for alignment on the fixture. |
| pfinn | Jetco Dayton-Wright RB-1 | Build | 22-Jan-11 22:07 |  |
| Views : 580 |
| Laminated top, bottom and side Keels with 1/32" Bass/Balsa/Bass/ Balsa. Vert stab profile is all Bass (to be sanded to taper thickness). Formers to be notched only at Keel junctures. I'm going to try building the fuselage on a "Jig". Never done it before. Something new for me. |
| pfinn | Jetco Dayton-Wright RB-1 | Build | 16-Jan-11 20:16 |  |
| Views : 564 |
| The scanned and then copied formers on the plan turned out to be distorted as well as some of the notches were quite off. I redrew them taking measurements off the side and top views to get the correct sizes and positions. |
| pfinn | Jetco Dayton-Wright RB-1 | Build | 16-Jan-11 20:11 |  |
| Views : 562 |
| The "Stix-It" actually sat for a couple days before I had a chance to heat bond them together. Worked fine. I also laminated the same matl's with white glue. The white glue yielded a more rigid plank. I believe that just a bit of "Resiliancy" or "Give" is a bit more durable. Hence my choice of using the S-I for these particular parts. |
| pfinn | Jetco Dayton-Wright RB-1 | Build | 16-Jan-11 20:04 |  |
| Views : 567 |
| I laminated two 1/32" inch Balsa sheets "Crossgrain" to make a more rigid fuselage formers. The forward three formers have a silk layer laminated in between. The silk was doped to the wood first, then, as with the Balsa only laminate, I used "Stix-It" heat activated adesive to join. This worked very well. I used our houshold iron to bond them together. |
| pfinn | Guillows Series 300 - Piper Cub 95 | Reference | 10-Jan-11 18:41 |  |
| Views : 1320 |
| There was a separate hall for FF and they had a building area for the kids to assemble some rubber power models and fly them. Jimmy and Katarina had a blast. We spent about 2 1/2 hours in there! Katarina won two 1sts in mass launches and Jimmy one 2nd place (due to aircraft breakage right before the call for a "Mass Launch"). Here's a vid of Katarina flying with about 500 winds: http://www.youtube.com/watch?v=7aSlEEizu_I And here's Jimmy with about 250 to 300 winds: http://www.youtube.com/watch?v=661VMtUYZTU |
