| Build Thread, Page :
<< 5 6 7 8 9 [ 10 ] (188 posts, 20 posts per page, 10 pages in total)
|
[ < Prev ] |
| mark eggebeen, Comment for image # 40591 | 19 Sep 18 11:38 |
| Don c. Can,t find you on the list |
| Don C, Comment for image # 40591 | 19 Sep 18 09:42 |
| John Oshust has a shaft made of brass tubes that allows them to spin. If he doesn't post a picture, I'll try to find one. You might try to make the a thicker plate, so you can drill holes in it for the blades after you attach the spinner. Take a look at my P-40, but ignore the huge screw I used. |
| mark eggebeen, Comment for image # 40591 | 18 Sep 18 22:33 |
| on the props thing...I'm worried about getting the plates into the spinners and the holes lined up in order to get the props in place in line and at the right angles. I'm still trying to figure out how to get them installed into the front of the plastic cowling so they will spin. |
| David Duckett, Comment for image # 40591 | 18 Sep 18 12:57 |
| This kit has plastic props. Cut them out, glue together, some filler perhaps, sand smooth and paint. |
| Don C, Comment for image # 40591 | 18 Sep 18 12:05 |
| Check out D Duckett's prop making in the "How To"s". |
| mark eggebeen, Image # 40594 | 18 Sep 18 11:02 |
this is the front landing gear with the pin attatched to go into the socket inside the wheel well |
| mark eggebeen, Image # 40593 | 18 Sep 18 11:00 |
I didn't want to work on this model woith the wire from the gear sticking out of the model ...so I put on a "socket: so I could insert the gear when the model was finished |
| mark eggebeen, Image # 40591 | 17 Sep 18 22:50 |
/just getting started...I need help on the props any one interested |
| Build Thread, Page :
<< 5 6 7 8 9 [ 10 ] (188 posts, 20 posts per page, 10 pages in total)
|
[ < Prev ] |
